How To Put A Watch Battery Cover Back On

Introduction

Watch repairs at a jewelry store can be expensive, and non all places accept the aforementioned brands. However, a self-repair can relieve watch owners time and money and requires picayune knowledge to exercise. This bombardment replacement guide for a Michael Kors Hartman Rose Gold picket will provide stride-by-step instructions to successfully deconstruct, supervene upon, and reconstruct the sentinel and its battery.

Thoroughly clean the watch using electronic wipes.

Thoroughly make clean the watch using electronic wipes.
Be sure to get around the battery cover and remove as much dirt, dust, and/or debris to ensure an easy removal.

Locate the spring pin under the band strap with the latch hole.

Locate the spring pivot nether the ring strap with the latch hole.
Insert a push-pivot into the pigsty.
Push against the spring pin as needed until the band strap pops out.
Remove the jump pivot.
Exist sure to place the spring pin in a safe location. Yous will demand it later for reassembling the watch.

Lay the sentinel clock confront down on a dry out, flat surface.

Place a spudger into the minor notch on the border of the bombardment cover.
Pry the bombardment cover, using every bit much strength every bit necessary.
How well you cleaned around the battery cover in Step i may determine how much strength you volition need to utilize.
Remove the cover and place it to the side.

Remove the plastic piece and set it aside.
Y'all tin can do this pace using either a spudger or your fingers.

Remove the bombardment from the lookout man.
You can do this step using either a spudger or your fingers.
Batteries are considered hazardous waste. Do not throw away the battery. Keep it until you are able to dispose of information technology properly. Depending on where y'all alive, some stores like All-time Purchase volition recycle batteries for y'all at no charge.

Insert the new battery into the watch.
Depending on the brand you lot purchase, the battery needs to be an SR616SW or a 321.

Insert the plastic slice back into the watch.
The inner flap of the plastic piece should lay right on top of the bombardment and embrace it completely.

Lay the battery cover dorsum onto the spotter.
There is a very small notch under the cover that should line up with the crown of the picket.

Press firmly on the battery embrace, using both of your thumbs to snap information technology back in place.

Re-insert the pin you removed into the hole of the smaller (lengthwise) folding segment.

Marshal both ends of the scout, holding the segment with the spring pin adjacent to the hole.

Utilise a spudger to press down on the spring pivot, guiding it into the second hole.
Release one time connecting segments are in place.

Optional: Use your electronic wipes to remove whatever unwanted fingerprints.
Place your wrist in the picket.
Relatch to ensure you correctly reassembled the scout.

Conclusion

Congratulations! You lot have replaced the battery from your Michael Kors Hartman Rose Golden lookout man. If y'all followed the pace-by-footstep instructions, you lot should now have a fully reconstructed picket that is properly working. If it is not working properly, go back and carefully echo the steps to ensure you completed everything correctly. Be sure to adapt the watch to display the correct time, and you will be prepare to go.